House in order to maintain a microclimate in a wooden house for the choice and installation of windows should be approached with particular thoroughness. Doors and windows should be wooden in order not to violate the movement of air flows in the room. The technology for installing windows in a log house is largely different from the methods used in installation in brick houses. In order for the window not to be deformed, you need to use a special system that will compensate for the voltage that occurs during the shrinkage of the house. Such a system is called a “burden” or “casing”. In fact, this is a wooden box that is installed between the wall of the house and the window. The lower part of the box performs the function of the window sill. It is convenient to fix the platbands on the side walls. The cost of making slopes is not required. Thanks to this system, thermal insulation of the room improves, drafts are eliminated. There are several windows of windows in the opening, one of them is called “floating”. At the first stage of preparation for installation in the wall, an opening is cut, which is 20 cm wide. exceeds the width of the casing. After that, the groove is cut and the veneers are cut into the end of the logs. After which all mounting gaps between the opening and the casing, which is collected using self -tapping screws, compacts. A box is installed in the opening, which is attached in the same way with the help of self -tapping screws. The upper gap is filled with mineral wool. For ventilation of the mounting seam from the outside, a special sealing tape is installed. After that, the window block is set in the casing and fastened with self -tapping screws. The space between the window block and the casing from the inside is covered with fillets. The platband is mounted in order to close the gap between the casing and the wall. This is where preparatory work on the preparation of the window opening for installing the window ends.
