The basement siding is one of the latest facing material, which has a lot of advantages. One of its main advantages is that its installation can be made with your own hands. For example, among the assortment of the basement of the basement there are panels, when installing which it is not required to carry out the checks and take into account temperature changes, since the panels already contain notes that show the temperature. The assortment also contains panels with a built -in thermometer. This siding, in addition, is also used for facade decoration.
When installing basement siding on their own, it is necessary to adhere to a certain instruction.
Calculation of the material. The perimeter of the room must be divided into 102. Siding should be attached to a wooden crate, which is pre -treated with a refractory solution. The installation must start and on the left of the right.
First of all, the first starting profile and the outer angle is installed. Then the next start profile is attached at a distance of 25-30 cm. You can go to the second outer corner, only after the end of the installation of the first row of panels, which will greatly facilitate the selection of the picture. When installing, it is necessary to leave a gap of 6 mm, as the panels can disperse.
Installation of facade panels of basement siding is as follows by their own hands. On the hooks of the front wall of the profile we put on the panel from top to bottom. Follow the drawing. Stainless nails from the middle to the edges we nullify the panel to the crate. In the deepening of the previous panel, we place the following by installing it on the start profile. Install the outer angle. Windows and doors framed by the bar.
Assembly of basement siding near windows and doors with your own hands. In most cases, in these corners you need to cut. Having determined, the distance from the last panel to the profile, taking into account the temperature holes, cut out the panel in the form of the window shape. If the panel is shorter than the window, then it is necessary to cut the Mr. If longer, then a P-shaped incision is made a little more than the window when expanding siding. Then the bar with nails is cut off, the clearance is drilled into which it is necessary to install the panels with the help of stainless nails.